How to install solar street light
Preparation before installing solar street lights
The latest solar street light lighting system mainly contains the following seven parts
Solar street light pole
LED street light head
Solar panel
Lithium battery storage and control unit
Solar panel bracket
Accessories such as waterproof wire, waterproof connectors and screws
Foundation cage buried in the underground
Check that the above accessories are complete and not missing. If there are any missing parts, please contact the manufacturer to send a replacement.
What is the lithium battery storage control all-in-one machine
Lithium battery storage control all-in-one machine contains four parts, they are aluminum in metal housing, lithium battery pack controller, controller, waterproof plug.
Solar street light wiring test before installation
Before installing the street light, you must test it in advance, and then install it after the test is normal. If you do not test and install directly, it is likely that because a certain accessory does not work properly and rework, that will certainly cause a great waste of labor.
At present, the latest solar lithium battery lighting system has a high degree of integration, as long as the corresponding wire plug-in is connected, plugged directly into it.
Solar street light diagram details are as follows
First led street light and lithium battery storage control all-in-one machine lamps plug connected, then the LED street light will also light up, and then connect the plug of the solar panel and lithium battery storage control all-in-one machine plug, if tested in the daytime, wait a few seconds, the LED street light head will go out, so that the whole system is normal, if tested at night, the LED street light head will not go out, indicating that the whole system is normal.
Check the solar street light video for more details.
Installation of solar street light
Installation of solar street light pre-buried parts
Solar street light foundation cage, also known as pre-buried parts, should be installed in advance, in order to carry out the normal installation of solar street lights. This work requires the use of excavators, digging a large hole of almost 1 meter cubic, and then pouring concrete to reveal the part of the foundation cage to be screwed, wrapped with tape to keep the screwed part of the intact and neat. Wait for about 30 days, until the concrete is completely dry, the whole foundation is very stable, and then the installation of solar street light pole.
Installation of lithium battery storage and control unit
Slip the screw that fixes the Li-ion battery storage control unit into the screw slot. The rails on both sides of the unit are reserved for the screw.
Fixing lithium battery box and solar panel bracket
Put the screw part through the solar panel bracket, either the corresponding nut tightened and locked, to ensure the stability of the lithium battery storage control unit.
Solar panel installation
Align the solar panel with the hole of the solar panel bracket, fix it with screws and lock it hard with a wrench to keep its stability.
Installation of LED street light head
Connect the LED street light with the light arm, insert the narrow end of the light arm into the light end of the LED street light, lock it with screws, put the LED exposed wire through the light arm and through the other end of the light arm.
Light arm and solar panel bracket connected to the pole
Attach the light arm and solar panel bracket all to the light pole, put the wire of the light fixture through the top of the mounting bracket and set aside.
Connect the luminaire with the lithium battery storage control unit
Connect the wire of the lamp post with the light source wire of the lithium battery storage control all-in-one machine, directly connect the plugs of the two wires together, wait for 15 seconds, then the LED light will light up.
Connect the solar panel with the lithium battery storage control all-in-one machine
Find the lead wire of the solar panel and the plug of the lithium battery storage control all-in-one machine connected to the solar panel, dock the two plugs together, wait for a few seconds, the LED light will go off, which means the system is working normally.
Install the light pole
The last step is to set up the light pole, connect the flange of the pole with the pre-built parts, and fix the screws with screws. So the whole installation of solar street light is finished.
Leave a Message
Your email address will not be published. Required fields are marked *